For each Vertical Curve, the required input data are:
The route section can also be as long, or as short, as required.Selection of Centre line or Offset calculations.The Chainage Interval required between Centre Line points.The lengths of all Transition curves, if any, for all the curves along the route.The circular Radii for all curves lying along the route.The (or ) co-ordinates for the Points of Intersection for all curves lying along the defined route (up to 100 curves).
These Start and End points represent the total length of the centre line, or offset line, to be computed.
Surpac saving sections plus#
The (or ) co-ordinates for the Start and End points of the section of the route to be computed, plus the chainage of the Start point.
Surpac saving sections series#